[PhilBot]

I'm looking at using SPI on the RoboRio.

I used it in 2012 on the CRIO, but as I look at the LabVIEW VI's there are obvious changes.

Unfortunately the "Detailed Help" still refers back to all the old 2013 VIs.

Some things I'm trying to figure out:

If I select the MXP interface, which pins are used for Clk and Data.
What are the Internal interfaces listed?
I get to select the Clock Rate. What is a reasonable Max for this input.

Any other peculiarities I should know?

Is there updated docs anywhere?

Thanks in advance.
Phil.