|
Re: pic: Programmers can CAD too
Obviously I don't know the whole design, so forgive me if this doesn't work at all with what you're trying to do.
Wouldn't it make more sense to increase the clearance between the legs of one of the channels and nest the other frame member (or two, as I assume there will be based on the setup) inside the wider one? That would remove the need to make separate brackets to connect the two and would remove several joints (potential failure points) from the picture.
Either way, just my $0.02
__________________
Thanks for your time,
Orion DeYoe
FRC Team 2252 "The Mavericks" 2011-2014 (Student)
FRC Team 5413 "Stellar Robotics" 2014-???? (Mentor)
2011: Drive Coach, CAD, Programming, Electrical
2012: Drive Coach, Team Captain, Team Representative, CAD, Programming, Electrical
2013: Drive Coach, Team Captain, Team Representative, CAD, Programming, Electrical
2014: Drive Coach, Strategy, CAD
2015: Team Founder, Design/CAD Mentor, Drive Coach
|