|
Re: 2015 Dashboard - How to use Custom Tab
Mark and Greg,
Thanks for the example! I was also confused because when I dropped a new indicator into the Dashboard Custom Tab I could not see the parameter in the block diagram panel. It took me a while to find the command to flip between both locations in the front panel and block diagram which located the parameter.
I also dropped a control into the Dashboard Custom Tab.
The indicator will receive the value sent from TeleOp.vi via the SD write VI correct? See picture.
__________________
Marc Center 
FIRST FRC Mentor/Coach - Team 3548 Royal Oak RoboRavens#2 - on Sabbatical 2017 season
marc.center@gmail.com
Mobile: 248-255-7377
Last edited by marccenter : 27-01-2015 at 13:23.
Reason: swap control with indicator?
|