|
Re: Talon SRX CAN Daisy-Chain Wiring
This should work fine.
Just a heads up, if you took a close look at the Talon SRX PCB, there is really no "daisy chaining".
Both yellow wires and green wires are soldered directly to the respective high and low pads.
I wouldn't worry about throwing on your own terminating resistor and instead, use the terminating resistor on the PDP.
Either will work.
__________________
-Kiet Chau
2004-2008 - Software Developer/Driver on Team #968
2008-2011 - Software Developer/Coach/Mentor/"Engineer" on Team #968
2011-Present - Mentor & Engineer on Team #1538
www.team1538.com
|