[tStano]

I'm struggling with this as well.
I've come up with 2 possible solutions:
1. Buy a second VRM for your camera(Honestly, this VRM seems poorly designed, I can't think of anything I would use any of the ports except the 5V2A for)

2. I'm not entirely sure if this would work, but I think you could use the router power supply from last year plugged directly into a wago on the PDP. That supply is a 12v-5v supply, but the camera requires a very specific voltage and I don't know how good the regulator is in the router power supply.
edit: I looked up the spec sheet for that, says it works from 10-30v, which doesn't sound too promising. I know our batteries get down below 10 during some matches.
Perhaps you could put that thing off the 12V2A rail of the VRM, although I'd advise against it, especially if you're using pneumatics with your compressor PCM plugged into the weidmuller connectors, because your compressor, solenoids, and anything off the VRM will run off a single 20A non-resetting fuse.