View Single Post
  #5   Spotlight this post!  
Unread 03-02-2015, 10:35
rich2202 rich2202 is offline
Registered User
FRC #2202 (BEAST Robotics)
Team Role: Mentor
 
Join Date: Jan 2012
Rookie Year: 2012
Location: Wisconsin
Posts: 1,148
rich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond reputerich2202 has a reputation beyond repute
Re: Help! Rookie with Pneumatics!!!

You have a high pressure gauge, a regulator w/ gauge for working pressure, a pressure switch, and a relief valve.

You should confirm that the regulator w/ gauge does NOT exceed 60 PSI.

You should confirm that the switch cuts off before 120 PSI (somewhere between 115-120 PSI).

The relief valve should open before 125 PSI (121-125 PSI).

The Robot Inspector will check for all of that, and adjust the component if out of range.

The actuators are after the regulator w/ gauge, so should never receive more than 60 PSI.

Last edited by rich2202 : 03-02-2015 at 10:41.