View Single Post
  #1   Spotlight this post!  
Unread 04-02-2015, 17:35
KettleFallsTeam KettleFallsTeam is offline
Registered User
FRC #4980
 
Join Date: Feb 2015
Location: Kettle Falls High School
Posts: 5
KettleFallsTeam is an unknown quantity at this point
Pneumatic Control Module Power Issue

Earlier in the 2015 build season we were working with the pneumatic control module to run the compressor and a couple of solenoids. Everything worked fine at the time, however we did not need it on the robot at the time so we took it off. Now we are trying to use the pneumatic control module once again, but we cannot get the control module to work. It acts as though there is no power going into the device. We checked the voltage on the wires that we have going into the device and it is a strong 12 volts. Yet, when its plugged in we do not have any status lights show up, and we cannot run the compressor, or any solenoids off of it.