Thread: Use of JoystickButton in Command Based does not activate PCM
View Single Post
  #9   Spotlight this post!  
Unread 02-04-2015, 08:19 PM
ozrien's Avatar
ozrien ozrien is offline
Omar Zrien
AKA: Omar
no team
Team Role: Mentor
  
Join Date: Sep 2006
Rookie Year: 2003
Location: Sterling Heights, MI
Posts: 516
ozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant futureozrien has a brilliant future
Re: Use of JoystickButton in Command Based does not activate PCM
Are you seeing the same problem with the EXACT sample project you posted earlier? Where you enable the robot and...
- PCM reports not enabled in the self-test
- PCM status LED blinks slow green [or orange if sticky faults are set] instead of fast green [enabled].
- solenoid led does not turn on when button is pressed (every solenoid channel has a red led at the case edge of the PCM).
All three symptoms are occuring? Or some of them?

Does the PCM still show up in the web-based config?
Is it's device ID zero?
Reply With Quote