|
Re: Using The Ekocycle
My suggestion would be to remove the cartridge and reinstall it. I have only used the Cube but the two main problems are either the filament is stripped and can't feed properly, or the filament breaks in the tube and the printer can only extrude the length that broke off. The latter is usually caused by the PLA drawing moisture from the air which increases brittleness.
__________________
2015 - Pioneer Valley District Finalists/Upper Darby District Finalists/MAR District Championship #1 Seed and Winners with 225 and 203
2014 - Lenape Seneca District Winners/Chestnut Hill District Winners
2013 - Lenape Seneca District Winners/Chestnut Hill District Finalists
2011 - Philadelphia Regional Finalists
2009 - Finger Lakes Regional Finalists
|