View Single Post
  #1   Spotlight this post!  
Unread 05-02-2015, 11:41
RobHammann RobHammann is offline
Registered User
FRC #5143
 
Join Date: Jan 2015
Location: Grand Rapids MN
Posts: 8
RobHammann is an unknown quantity at this point
PCM IS NOT ENABLED

I am trying to get our compressor to turn on, and it was working a few days ago. Now when the robot is turned on the PCM flashes green slowly, and the self-test in the web interface says:

"PCM IS NOT ENABLED! If the robot is enabled maybe the ID is wrong? Close Looping is ON, but PCM is DISABLED Comp is OFF Pressure is not full"

I am using c++ to code, and I have 2 solenoids declared
The compressor is wired to the PCM, but it reports no power to the compressor.

Is the compressor not working? Is the PCM broken? Do I need to add more code?