Quote:
Originally Posted by Mark McLeod
It means you probably copied the example a little too exactly.
Your drive motors are named "Left and Right Motors"
The example however uses motors named "Robot Drive"
Change the name in the example from "Robot Drive" to "Left and Right Motors"
|
You will also see this in LabVIEW most of the time. It is a warning and as long as you do not get a fault then you are OK. If your timeout gets too long you will get shut down during the match. Everything uses a watchdog timer. Basically it tells the field that you are still there. If it takes too long then it shuts you down.
Make sure that you are not putting all of your code in the teleop loop. You need to move non time critical operation outside of teleop.