|
Re: LabVIEW code to drive 4 motor chassis
That should work alright then for four Talons.
The additional inverts are fine.
So, - Double check the orientation of the PWM cables going to the two Talons that don't light up.
- Pull the breakers for the Talons that are working, then test using the unlit Talons to see if they output any power. It's possible they just need to be calibrated.
- You can also try taking one of the PWM cables running to a working Talon and connect it to one of the non-working Talons to see if it's the cable itself.
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 06-02-2015 at 09:04.
|