Quote:
Originally Posted by Alan Anderson
Re-route your main power wiring to go to the hinged side, so you don't have to disconnect it from the main breaker in order to rotate the board. Either that, or mount the breaker to the board and ensure that it can easily be seen, reached, and switched when the robot is in its competition configuration.
|
Ah. That makes sense. However, all of the cables that are already rotating on that hinge are signal cables, travelling through an O-channel, rectangular channel. That should pass inspection should it? If I should wire the 6 gauge wire through the same channel, will it also pass inspection? The channel is spanning vertically though the robot, and is about 3 feet long.
Thank you so much!