Quote:
Originally Posted by jman4747
Ours has worked very well so far too. Encoder mounts, Jigs for hole patterns, Jetson TK1 mount, custom electronics mounts. And more to come. Also haven't needed anymore filament. Also if you want clearance for #8 screws use .190" for the hole diameter. For 1/4"-20 use .280".
Note; It's usually cold in our shop (40-60deg F)
|
40-60f and that's "cold" I wish our shop was that "cold". We barely get heat in our shop so we get down to single digits at some points.