Thread: Design and engineering mgmt rules
View Single Post
  #3   Spotlight this post!  
Unread 12-02-2015, 15:48
Lil' Lavery Lil' Lavery is offline
TSIMFD
AKA: Sean Lavery
FRC #1712 (DAWGMA)
Team Role: Mentor
  
Join Date: Nov 2003
Rookie Year: 2003
Location: Philadelphia, PA
Posts: 6,564
Lil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond reputeLil' Lavery has a reputation beyond repute
Send a message via AIM to Lil' Lavery
Re: Design and engineering mgmt rules
Quote:
Originally Posted by ToddF View Post
25) Use hex shafts rather than round shafts with keys.
I have yet to see suppliers run out of round bore bearings or half inch, keyed round driveshaft during build-season