|
Re: Al's Annual Inspection Thread 2015
Batt,
It is possible to have a problem in wiring or to have an issue with the CAN bus interfaces. I suggest checking the user's manual for the PDP first and then try checking with CTRE to see if there is something else that you can check.
The correct operation is to vent at 125 psi or above. This part has a repeatability of +/- at least 2 psi. A good indication is a wet finger on top of the valve. Venting will cause some bubbles.
__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.
|