Thread: Tapped Drill motor holes: thread anyone?
View Single Post
  #2   Spotlight this post!  
Unread 16-01-2002, 05:10
Lloyd Burns Lloyd Burns is offline
Registered User
FRC #1246 (Agincourt Robotics)
Team Role: Engineer
  
Join Date: Jun 2001
Rookie Year: 1997
Location: Toronto
Posts: 292
Lloyd Burns is an unknown quantity at this point
The sheet I have, a third or fourth generation copy, calls the tapped holes "2 - M4.0 / Tapped holes". Note 6 says "tapped / holes can accept a maximum usable male screw or pin length of 3.0 mm".
HTH