Quote:
Originally Posted by Alan Anderson
The CUI encoders are great, but finding a good mounting solution for available COTS gearboxes is still a challenge this year. I'm considering the included brackets expendable -- I don't think we have managed to remove a single encoder without breaking at least one of the three clips. Who's up for designing a 3d-printable one that accommodates the mounting holes on AndyMark gearboxes?
|
Completely agree. If you never have a need to remove the mounting plate then these encoders would probably be great. We needed to change the mounting of a couple of them though and the little plastic clips popped off one after the other.