Thread: Drill Motor and FP Motor Shaft Diameters
View Single Post
  #3   Spotlight this post!  
Unread 01-06-2001, 11:12
Andy Baker's Avatar Woodie Flowers Award
Andy Baker Andy Baker is offline
President, AndyMark, Inc.
FRC #3940 (CyberTooth)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 1998
Location: Kokomo, Indiana
Posts: 3,412
Andy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond reputeAndy Baker has a reputation beyond repute
Send a message via AIM to Andy Baker
I found some data... FP is right, but Drill is 4mm
Looking at my CAD files, I modeled the shaft of the Drill motor at 0.157" (4mm).

I'm pretty sure that this is right. I just wish that I had a motor in front of me to confirm this.

Andy B.