Quote:
Originally Posted by MaGiC_PiKaChU
1- we had tons of data cables, so we cut one side to connect each wire individually... you could also plug a small wire into each hole, but that would be harder
|
Cutting them would make it hard to plug them into the breakout board later.
Just the same, we have had a lot of difficulty trying to find wires small enough to fit into the data cable's slots. Do you know what each hole does on the data cable?
Quote:
Originally Posted by MaGiC_PiKaChU
2- No, your RoboRio has its own IP address, it changes if you connect via USB or ethernet. I don't remember the defaults, because we changed it to 10.33.60.2 as soon as we got it. You can find this address somewhere in the user's manual  |
The IP changes?? you mean it's not “roborio-XXXX.local”
where XXXX is the team number? It has an extension such as .2 or .6?