Quote:
Originally Posted by Kevin Ray
Man! Now THOSE were the days... We'd spend 2-3 weeks just getting the drive train to work.
Now, so as to not hijack this thread, I'd like to have a set of hole cutters like these: http://www.mscdirect.com/product/details/98332570 but 5 thou undersized so that we could press fit bearings into the hole. |
Toolpost Grinder? I recently ran into an issue tapping a 1/4-20 hole, had to tap past the shoulder and had no reduced shank tap. Put my tap in the Bridgeport spindle and a Die Grinder in the vise and reduced the shank in about 15 minutes.
Good times.