[Greg McKaskle]

I believe that the network settings are being changed by the Driver Station rather than by LabVIEW. What happens is that the DS assumes you launched it in order to connect to the robot. It will check the settings using ipconfig, netsh, and other commands and will offer to change the settings. When it changes them, it stores the old settings in a file called

FRC Restore My Network Settings.bat

This is stored in the Users/Public Documents/FRC directory, and it is a simple batch file that points to a restore file made by netsh the first time the DS ran it.

So assuming this is the issue, you may just need to get in the habit of running the batch file when you are done.

Greg McKaskle