Thread: Labview keeps messing up ethernet settings
View Single Post
  #13   Spotlight this post!  
Unread 09-06-2015, 10:52
Mark McLeod's Avatar
Mark McLeod Mark McLeod is offline
Just Itinerant
AKA: Hey dad...Father...MARK
FRC #0358 (Robotic Eagles)
Team Role: Engineer
  
Join Date: Mar 2003
Rookie Year: 2002
Location: Hauppauge, Long Island, NY
Posts: 8,795
Mark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond reputeMark McLeod has a reputation beyond repute
Re: Labview keeps messing up ethernet settings
In the Driver Station:
  1. Go to the Setup tab
  2. Click on Choose NIC...
  3. Choose "I will configure my wireless adaptor manually"
  4. Choose "I will configure my ethernet adaptor manually"
  5. Click OK
  6. Use the red X (on right side by the Charts tab) to quit out of the Driver Station application.
  7. Reset your desired network adaptor settings manually to be what you want them to stay.
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 09-06-2015 at 10:54.
Reply With Quote