|
Re: Pneumatics programming help needed
Remove everything from the False Cases and it should work.
There are two issues. - The On/Off doesn't work with a double solenoid
- Both cases are executing at the same time, so they are clobbering each other. It will work if the False cases are empty and both buttons are not pressed at the same time.
A better technique is to only set the solenoid in a single place outside both cases.
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 13-06-2015 at 23:17.
|