Thread: pic: GBX-127, bevel-beside-wheel swerve drive
View Single Post
  #10   Spotlight this post!  
Unread 10-08-2015, 17:20
R.C.'s Avatar
R.C. R.C. is online now
2017... Oooh Kill em, Swerve!
AKA: Owner, WestCoast Products
FRC #1323 (MadTown Robotics)
Team Role: Engineer
  
Join Date: Feb 2008
Rookie Year: 2006
Location: Madera, CA
Posts: 2,172
R.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond reputeR.C. has a reputation beyond repute
Re: pic: GBX-127, bevel-beside-wheel swerve drive
Is your Ma3 1:1 in relation to the steering portion of the module? It looks that its part of the first stage of the rs gearing.

Edit:

1. If your pressing the bevel gear into the wheel, why not put bearings into the wheel and make the assembly dead vs live? It would make the bottom of your module way more rigid. Also much easier to do wheel swaps, we were able to do wheel swaps in under 10 seconds on our modules this year.

2. I would recommend milling the side of your forks and adding a bearing to support the smaller bevel gear.
__________________
R.C.
Owner, WestCoast Products || Twitter
MadTown Robotics Team 1323
Last edited by R.C. : 10-08-2015 at 17:37.
Reply With Quote