View Single Post
  #25   Spotlight this post!  
Unread 15-08-2015, 14:55
Chak Chak is offline
Registered User
AKA: Thomas
FRC #4159 (Cardinalbotics)
Team Role: CAD
 
Join Date: May 2015
Rookie Year: 2014
Location: San Francisco, California, USA
Posts: 261
Chak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant futureChak has a brilliant future
Re: Gearbox Design Feedback

Quote:
Originally Posted by ARI423 View Post
From what I can see, the two screws holding in the CIMs are accessible from the outside. One screw looks to be the top standoff screw, and there is a hole (in line with top and bottom standoffs, below CIM output shaft) to unscrew the other screw. Then it should be as simple as popping off the CIM gear and sliding it out of the enclosure. I could be wrong, but I imagine this was SerpentEagle's intent when designing it.
Quote:
Originally Posted by SerpentEagle View Post
Would loctite solve this problem? But yeah I could probably just run the bolt all the way through to the CIM.
Wouldn't that ruin the accessibility of the CIM in the original design?
So Loctite would be the better choice.