|
Re: Driving 2 motors at the same time
Here is a thread that talks about how to do this. Read Greg's posts in particular.
Running each robot on a separate SSID is probably the easiest. The typical non-event way to this is use the robot radio as an AP & set the SSID there. make sure the DHCP is turned on in the AP. (For the roborio class bots). Connect the DS computer to the robot you want to drive.
For the Roborios. You can go into the configuration web page and change the MDNS name there. Easier than doing all the other stuff.
__________________
If you don't know what you should hook up then you should read a data sheet
Last edited by FrankJ : 11-09-2015 at 09:41.
|