Quote:
Originally Posted by Brian Selle
Great job guys, very impressive. What kind of spindle/router did you use?
|
We are using a 3HP, ADES70, 24,000 RPM Electric Spindle from
here.
Quote:
Originally Posted by Kstuck
Very impressive!
Could you share what you use for hardware and software on the control side?
Thanks for sharing!
|
We are running AMC motor controllers and brushed motors with USDigital encoders for hardware, the software is LinuxCNC.
Quote:
Originally Posted by thatprogrammer
Have you had issues with belts stretching?
|
Not that we can tell, but it is still relatively new. The belts shouldn't stretch, but if they do we can re-tension them.
Quote:
Originally Posted by MattRain
Any links to these pictures? Would like to see what we are talking about.
|
Our picture album originally referenced is
here