Quote:
Originally Posted by silverD
Here is more info on the GoPro stand we made.
Parts: Stand and Pole.
We had to sand down the inside of the plastic top ring on the stand so that the pole would slide inside. We also removed the bottom cap of the pole and drilled a hole through the center and near the bottom of the outer pole so that we could put a bolt through both the stand and pole to prevent it from sliding down. In the pics below neither the stand or pole have been extended and it's about 8ft.
Let me know if you have questions,
Nate
 |
Come to think about it I have light stands that I can extend at about the same size. I'll attach it to that.