Quote:
Originally Posted by BenGuy
Shashank, if we were to make this in the near future, you'd have to simplify the part, there is no way that this can be made on the bridge port, this would have to laser cut and we usually can't cash in on our sponsorship benefits from Superb until well into build season. Even if it will weigh a half a pound more, that's fine, just make an iteration that is feasible to make parts for on the mill if we are going to need it in the near future.
|
I've been looking into better optimizing parts for machine time over this off-season, especially gearbox plates like these which sucked up a ton of waterjet time for us. One thing I'm exploring is using unpocketed 1/8" plates with additional standoffs, after looking at 2826's robot.