[cbyrne]

Hello CD readers!

I am working on a design for a <3"x3" board to break out the Teensy 3.1/3.2 pins to individual or paired Molex SL latching connections, same as what Hansen sells as Latching Polarized connections. Similar to servo connections, where there are one or two signals, plus power and ground.)

Currently, the board is looking like it will have:
8 Digital I/O only lines,
12 Analog In or Digital I/O
SPI
CAN
2 or 3 Serial (notionally one RS232 and one TTL)
2 I2C

Trying to gauge interest among the community if this will be something they are looking for. Any requests, reply below. Plan is to release the board as Open Hardware, but because the connectors can get expensive, looking into bulk buys and selling kits.

Thanks for the input!