Quote:
Originally Posted by Nathan Streeter
Being a team that works with wood a tremendous amount, you probably know... but is a .5" hex sufficient for a wood drive wheel (even if it's only ~4" diameter)? I would think you'd at least want to make sure the interface didn't have slop.
|
I believe this is the answer (emphasis mine):
Quote:
Originally Posted by GUI
It is designed to mount a VersaHub to interface with a 1/2" hex shaft, and the blue nitrile tread is attached with CA glue and staples.
|
As I read it, the hex hole in the wood isn't for torque transfer, but presumably for alignment.