Quote:
Originally Posted by loganc10
|
This is kind of unrelated to the other conversations here, but I thought I would offer my own suggestion against using this type of set screw hub. I have had to deal with getting these to fit just right and keeping the setscrew from backing out and it is a pain. Especially with your CIM at 5000+ RPM I think this is going to be a headache for you.
I would recommend using
this coupler on your CIM shaft to make it so you can use any wheel with a Hex bore. Then you could use
tons of different
wheels as long as they have that Hex hole in the middle. You would also be able to use
this hub to connect to wheels without the hex hole in the midle.
It's totally up to you (and I know you already sunk money into that hub), but I just hate trying to use set screw hubs on a keyed shaft.