Thread: Presses and techniques for 1/2" HEX broaches
View Single Post
  #3   Spotlight this post!  
Unread 04-01-2016, 00:02
thinker&planner thinker&planner is offline
Registered User
AKA: CAAAAAD
no team
Team Role: Mechanical
  
Join Date: Jan 2013
Rookie Year: 2013
Location: Tallahassee, FL
Posts: 115
thinker&planner is a splendid one to beholdthinker&planner is a splendid one to beholdthinker&planner is a splendid one to beholdthinker&planner is a splendid one to beholdthinker&planner is a splendid one to beholdthinker&planner is a splendid one to beholdthinker&planner is a splendid one to behold
Re: Presses and techniques for 1/2" HEX broaches
Quote:
Originally Posted by asid61 View Post
I calculated that that cylinder only puts out about 1000lbs of force on 100psi. Were you planning on adding a lever arm or something, or is that enough to force a broach though?
I honestly have no idea. I wish I knew, because then I might pursue it further.

Quote:
Originally Posted by asid61 View Post
I feel like I'm missing something. What's wring with just using the 1/2" shank on the bottom of the broach to keep it straight? Is that not good enough?
We broached some HTD 5mm pulleys that were 1/2" wide, and a few of them came out crooked. This was probably due in part to poor technique (and execution), but I would not trust most of our team members using our current setup for high-speed applications. (where the broached piece is running at high speeds)