View Single Post
  #3   Spotlight this post!  
Unread 05-01-2016, 07:40
aldaeron aldaeron is offline
Registered User
AKA: -matto-
FRC #1410 (Kraken)
Team Role: Mentor
 
Join Date: Jan 2010
Rookie Year: 2010
Location: Denver
Posts: 224
aldaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond repute
Re: Sonic Shifter - recent feedback?

Quote:
Originally Posted by cbale2000 View Post
I don't think the issue is the plate stiffness, but the fact that the small output gear (the one with the missing teeth in the photo on the last page) is on a cantilevered shaft. If one was to modify the plate so that another bearing could be used on this shaft, there likely would not be any problem.

On a related note, our team actually did this recently with a pair of VexPro 2 CIM Ball Shifters that we had inadvertently ordered without the 3rd stage (and apparently the output shafts on the 2nd stage are longer when order it like this). So we made a pair of replacement plates so that the smaller 3rd stage gear could be retained by an additional bearing instead of having to remove the shaft and lathe a snap ring channel into it.
Wow I had never noticed that the output gear is unsupported on the 3rd stage for both the 2-CIM and 3-CIM ball shifter. For the 3-CIM I saw the hole in the plate and assumed it was 1.125, but it is only 1.000. Perhaps Vex thought the extra bearing would over constrain the shaft? A rare miss by Vex. The being said, the gear separation is 84T, so you could add some of my new favorite part, the Face Bearing Mount.

I am curious if you mounted your wheel right the to the output shaft or if the shaft was supported? I would take the 3rd stage output shaft and put two chain sprockets on in, then pass it thru a VersaBlock and put the wheel on the other side of the tube for a WCD setup.

The more you learn ...