Hello! Thank you for taking the time to read my post and hopefully help me!
I almost completely understand how to take the values from a digital input/analog input and utilize them within our team's code, but I have no idea on where to even begin on the roboRIO itself.
For example, if I wanted this simple switch mounted on the robot to control whether the robot ran our autonomous code or did not run our autonomous code, how would I wire it to the roboRIO DIO so that I could call for it's T/F value in LabView?
The same question applies to this potentiometer, except for analog values rather than T/F.
This is a very rudimentary question that you can probably answer in minutes, but I just wanted to ask the you guys first so that I don't accidentally hurt the board. I couldn't find my answer after using google for an hour because I don't know the proper terms. Thank you for your help!
Bonus Question: What would a potentiometer that has specific values be named? Specifically one that has at least 4 distinct analog value outputs.