View Single Post
  #2   Spotlight this post!  
Unread 14-01-2016, 15:31
MrJohnston MrJohnston is offline
Registered User
FRC #0948 (Newport Robotics Group (NRG))
Team Role: Teacher
 
Join Date: Feb 2013
Rookie Year: 2011
Location: Bellevue, WA
Posts: 378
MrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond reputeMrJohnston has a reputation beyond repute
Re: Bumper clarification

From Q&A:

Q520
Q. Bumper rule R19 states "If a side is shorter than 8 in., the entire side must be protected by BUMPER". If the side is 27" with a 13" cut-out (14" remaining) does the 8" minimum apply or is the 7" on either side of the cut-out considered a full side less than 8"?


A. Per the Blue Box below R19: the dimension defined in R19 is measured along the FRAME PERIMETER. A lack of physical frame elements between corners of the FRAME PERIMETER does not change the length of the FRAME PERIMETER side.