|
Re: Ball Intake Mechanisem
I've been wondering how much compression works well on these balls. I haven't had a chance to prototype. Should the bottom of intake rollers be 8 inches off the ground? 9 inches? 9.5 inches?
Build blitz designs are great resources, but the properties of this ball are significantly different.
__________________
2014: EtaBot - MWR/30th place/no PO
2015: ThetaBot - MWR/30th place/no PO, R2OC/Winners, IndyRAGE 5th Alliance, WMRI QF
2016: IotaBot - MWR/16th place/QF, R2OC/7th Alliance Captain/QF, Boiler Bot Battle/6th place/Finalist
|