Quote:
Originally Posted by BBray_T1296
I took the CAD of the hub off of Andymark and modified it to be a bit more 3D printer friendly.
If anyone is feeling brave enough to try running a printed hub, I posted it to Thingiverse.
It should fit any 200x50mm tire and inner tube which can be found all over the place. |
Be sure that the outer diameter is thick enough, I had trouble with it not having the thickness to get three full layers in so I ended up with two layers and a hollow gap between them.
Did you remove all of the fillets? Doing that cut supports in half after I took the draft off and made my own spokes so it would be prettier.