View Single Post
  #5   Spotlight this post!  
Unread 18-01-2016, 10:04
aldaeron aldaeron is online now
Registered User
AKA: -matto-
FRC #1410 (Kraken)
Team Role: Mentor
 
Join Date: Jan 2010
Rookie Year: 2010
Location: Denver
Posts: 224
aldaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond reputealdaeron has a reputation beyond repute
Re: Bumper "Side" Clarification

If this is a top view, the edge of your FRAME PERIMETER is the 24 inch dimension and therefore you have to cover 8 inches on either side. The bumper shown would not be legal.

See this Q&A

If in doubt, imagine pulling a string all the way around the outside of your robot. This defines your FRAME PERIMETER. Each of the sides of string now needs to have at least 8 inches of bumper on it, and each end of each bumper piece needs to be supported (at least 1/2 inch per R26).

-matto-