Thread: CAN can not see PDP
View Single Post
  #8   Spotlight this post!  
Unread 18-01-2016, 19:12
ozrien's Avatar
ozrien ozrien is offline
Omar Zrien
AKA: Omar
no team
Team Role: Mentor
  
Join Date: Sep 2006
Rookie Year: 2003
Location: Sterling Heights, MI
Posts: 522
ozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond reputeozrien has a reputation beyond repute
Re: CAN can not see PDP
On the PDP that is connected to the roboRIO directly (no PCM), disconnect CAN and confirm the PDP LEDs change to blink-red-only. Then reconnect the CAN wires to the PDP to confirm it transitions back to blink-green-only (or blink-orange-only due to sticky fault).

Be sure to clear the column filter on the left above the treeview.

Make sure jumper on PDP is on the TERM. ON position.

Follow the cable from the RIO to the PDP to ensure CANH goes to CANH and CANL to CANL.

Sanity check: the PDP was flashed with 1.40 and the RIO was flashed with image19?