|
8' pneumatic wheel conversion setup
Team 3366, Roscoe Plowbots here, we have tried this conversion kit; however, we could not find the order to assemble it. We finally discovered that it requires some self manufacturing. Here is what we did:
Main Hub: hub ground down 3/8'- pulley - wheel, - pulley spacer w/ pulley end cap - hex nut
Right Wheel: small white spacer - large white spacer - inset pulley spacer - pulley - wheel - 34mm custom spacer
Left Wheel: small white spacer - large white spacer - wheel - 34mm custom spacer.
This is for the pneumatic 8' square drive train with 6 wheels. We used a small pvc pipe for the 34 mm custom spacer. Note: on left wheel you do not use the inset pulley spacer, if you do your bolts will get caught on the frame of the robot.
|