|
Re: Angle of ramps?
If you take the thickness of the sheeting into account, you can get much closer to this angle. Working backwards, A 12" hypotenuse at 13.5 degrees would be 2.88" off the floor at the high end.
Also remember that the field NEVER matches the drawings to within stated tolerance. Especially if you design specifically for it.
__________________
If you can't find time to do it right, how are you going to find time to do it over?
If you don't pass it on, it never happened.
Robots are great, but inspiration is the reason we're here.
Friends don't let friends use master links.
|