Thread: Communication between BeagleBone and RoboRIO
View Single Post
  #1   Spotlight this post!  
Unread 22-01-2016, 09:37
ProfessorAlekM ProfessorAlekM is offline
Registered User
FRC #6190
  
Join Date: Jan 2016
Location: Canton, Michigan
Posts: 32
ProfessorAlekM has a little shameless behaviour in the past
Communication between BeagleBone and RoboRIO
Hello!

Sorry if this has been covered on this forum before, but I can't figure out any way to connect my BeagleBone to the RoboRIO.

My goal is to have the BeagleBone and the RoboRIO exchanging strings of data (ie. coordinates). At first I looked into using i2c, then I heard there was UART, but I can't find any tutorials on how to use either of these interfaces. I need to find a communications interface that is supported by both the BeagleBone and the RoboRIO.

Thanks!
Reply With Quote