|
Tuning PID
On our robot is an arm with 3 positions
Up
Middle
Down
Middle is about 1/4 the way between down and up (closer to down)
We control the arm with encoders on AM-2971 motors. When we tell the arm to go from up to middle, it gets to the position fine, but when we go from down to middle, it undershoots and only goes about halfway.
The current PID is 2, 0, 0.
What can we change to make the arm not undershoot when moving the short distance between down and middle?
__________________
There are two ways of constructing a software design: One way is to make it so simple that there are obviously no deficiencies, and the other way is to make it so complicated that there are no obvious deficiencies. The first method is far more difficult.
2012 - Gracious Professionalism - Greater DC
2014 - Regional Finalist - Virginia | Industrial Design - Virginia | Regional Finalist - Greater DC
2015 - Innovation in Control - Greater DC
2016 - District Event Winner - VAHAY | Innovation in Control - VAHAY | District Event Winner - MDBET | Industrial Design - MDBET | District Champion - CHCMP | Innovation in Control - CHCMP
|