Quote:
Originally Posted by pribusin
Are you using CAN or PWM to drive the Talons? If you use CAN you may need to re-address them. Check the GUI on the RoboRio for proper device IDs. We've not upgraded ours yet but I know sometimes a f/w upgrade can wipe out configuration data.
|
We are using CAN, but the Device IDs stayed the same. It was interesting, because there were no CAN errors when diagnosing the issue.
Quote:
Originally Posted by ozrien
A firmware update should not cause any settings to reset. See section 16.20 in the Talon SRX software reference manual.
|
It didn't seem like the settings reset, everything stayed the same except for the firmware version.