Quote:
Originally Posted by Richard Wallace
Can you point me to a C-C distance calculator that works with the GT2 3mm 12 tooth pinions that WCP sells? The one at SDP-SI only goes down to 16 tooth.
I would like to use this pinion to drive a 44 or 45 tooth pulley from SDP-SI. Will exact C-C set up work, or will I need a side tension system to keep six teeth of the pinion engaged to the belt?
|
You can change the type of pulley to "timing pulley stocks" to get down as low as 6t. You also have to go to Metric instead of Inch.
EDIT: I got the same result but with only 5 teeth in engagement.