[paul.dornfeld]

Originally Posted by nighterfighter

The WAGO slots on the PDP are the "ports" that you plug your motor-controller wires into.

You can not (FRC-legally) modify the PDP to have more WAGO slots. The MORE board allows you to have more PWM outputs, but won't actually give you more WAGO slots.

Edit:

As to your question about the "Y" connector:

Yes you could do that. Make sure that each CIM motor is connected to it's own motor controller, and each of those motor controllers are connected to different WAGO slots.

Keep in mind, whatever PWM signal you send into the "Y" cable will be sent to both. You can't address each motor controller individually that way. So make sure that the motors spin the correct directions and aren't fighting each other once inside the gearbox.

Fantastic info. Thank you.