|
Re: Encoder on SRX Returning wildly differing values
Quote:
Originally Posted by gpetilli
I would start by swapping the wires from the encoders to the SRXs to see if the speed follows the encoder or the SRX.
If the encoder, reseat the optical disk using the spacing tool that came with the encoder. A long shot, but check the lines per rev on the optical disks, there are several options available from 100 per rev to 360 per rev. You can try to count them  or the count should be engraved on the inner hub of the disk.
If it follows the SRX it is most likely an error in the code or that one SRX had it's defaults changed (perhaps last year) and the other did not.
|
The long shot was most likely the problem. Electric engineer was available tonight to come over and break it down. Turns out that the optical disk on one side is 250 and 360 on the other. The person doing the work to mount them must not have seen it.
Last edited by Tparbotmail : 27-01-2016 at 21:33.
Reason: Follow up
|