[Jon Stratis]

Just a nitpick here... But a lot of these posts seem to be saying/implying that something needs to go in front of the wheel. That is not actually the case. Something (greater than 1/2") needs to go into each corner, and that something needs to protrude past the wheel in order to define the frame perimeter. Another something needs to be extended less than 8" from the corner to properly support the bumper, and must extend that support to the edge of the bumper, assuming an 8" bumper (and must be at least 1/2" at the edge). All this can be accomplished without having any frame material in front of the wheels themselves, And actually be accomplished easily assuming there is enough room in the FRAME PERIMETER to accommodate the corner pieces.